jsansom

Hi all,

Although i am new to this forum I have been spending ages trying to fix my problem myself reading posts on this forum but so far no luck :>)

I have a parallel nv4 on my club cops and robbers gold and inside is a scorpion 4 board which I have now learnt has the loom that connects down at the bottom right hand corner where it has a T loom and this connects then to a little board under my scorp 4 board i think which is a security pcb. I cant get the note reader to work it just ejects the notes after it takes about 1cm of the note in and the leds number 2,3 flash, I have tried entering the bnv code 1-6 but the machine just says bnv note acceptor not responding or similar message.

Im guessing this is because I am connecting the parallel nv4 via this serial/security pcb loom instead of a parallel board so I have purchased a parallel/bell fruit scorpion 4 note interface pcb but now dont know what cable to connect to this board as the end of my loom goes into the T connector then off to the security/little board under the main board any ideas please.

Thamks in advance

J