Chat

Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

gazspence

Member Since 20 Dec 2004
Offline Last Active Dec 24 2004 10:34 PM

Find content

Posts I've Made

In Topic: JPM High Roller Help

24 December 2004 - 12:01 AM

Many Thanks to you both for your advice

I have taken you advice and posted the question on MPU Mecca

I Knew that the payout did not work when I purchased it, I just see it as a bit of a challenge to get it working. All other aspects of the machine are fine.

Have a great Christmas! :oops:

In Topic: JPM High Roller Help

23 December 2004 - 11:02 PM

Thanks for the Info

After looking at the JPMMps2.doc I am fairly sure That it is an MPS2 unit.

Sorry for yet another question I have just had a thought that I may be more dum than usual. If the tubes are all empty would it actually attempt to payout anyway ie fire the tube servos?

Anyway if I have done this correctly I have attached some pictures

Thanks Again

In Topic: JPM High Roller Help

22 December 2004 - 11:41 PM

Thanks for the reply Most helpful :lol:

I have had a good look around inside the Machine and noticed that the PSU has a 6 pin socket marked Con1 and on the mainboard there is an identical socket marked Direct O/P, Should there be a cable connecting these 2 sockets? Oh and the mainboard is marked MPU2 if that is any use

Thanks again