1 reply to this topic

[civilcalc]

hoping that someone can help me manually wire a NV10 into a MPU5 machine. I am unable to find a loom for it. 

 

The NV10 has the following pins;

 

1 Vend 1 Output Serial Data Out (Tx)

2 Vend 2 Output DA3 Data Logging

3 Vend 3 Output Not Used

4 Vend 4 Output Not Used

5 Inhibit 1 Input Serial Data In (Rx)

6 Inhibit 2 Input Not Used

7 Inhibit 3 Input Not Used

8 Inhibit 4 Input Not Used

9 Busy Output Not Used

10 Escrow Input Not Used

11 USB + Data USB Data +

12 USB - Data USB Data -

13 USB Vcc Power USB Vcc (+5VDC)

14 Factory Use Only Do not connect

15 + Vin Power +12VDC Supply

16 0V Power 0V Supply (GND)

 

And another thread on here suggests that the MPU5 Aux pins are;

 

1 - aux0.7
2 - aux0.6
3 - aux0.5
4 - aux0.4
5 - aux0.3
6 - aux0.2
7 - aux0.1
8 - aux0.0
9 - /aux_int1 - handshaking
10 - /aux_int0 - handshaking
11 - aux_strb - strobe data from or to external equipment
12 - 5v
13 - 12v
KEY
15 - GND

 

It feels like 12v and 0 are easy - and I think I need to connect pins 1 & 5 on the NV10 to pins 9 and 10 on the MPU5 but not very sure. Any help would be awesome. :-) 

 

[superbaron]

Hello civilcalc

 

You should also post the problem you have with The NV10 on www.fruitemu.co.uk in the help section of the website you might get better results because more people with real fruit machines go to that site. Hope you find what you are looking for.

Edited by superbaron, 30 October 2021 - 10:26 PM.