Update - Have fitted new Epoch board but problem still the same. Have removed PSU to see if that is the problem. No burns on power supply connector.
If there is a problem, will i lose one of the LEDs on the PSU? Or can it still be faulty with all LEDs lit?
Best way to check it works fine?
EDIT - Upon further inspection all LEDs are on but the -12v LED is off?
EDIT 2 - Have just checked all outpt pins from the PSU. All are around abouth 10.9v. Is this correct?
Edited by astaroth, 15 October 2014 - 12:13 PM.