Jump to content


Member Since 22 Oct 2006
Offline Last Active Mar 05 2007 10:44 PM

Posts I've Made

In Topic: MayGay 'Fruit'n'Nudge' Club Help...

05 March 2007 - 10:03 PM

Here we go... a few photos

The main board / roms, the reels (why?), the machine itself, and a piece of paper attached to the back of the machine, which is of no real use for my problem, but may be of use to others...

Comments etc, please :)

Oh, and if you can help with my problem... that'd be grand too :p

In Topic: MayGay 'Fruit'n'Nudge' Club Help...

05 March 2007 - 06:33 PM

Sure, I'll do that.

How do I get it in the scanner without breaking it? ;-)

No, seriously - I'll get some photos, and of the board etc...

Sneaky: what a way with words you have lol. ;)

Mine's set on 10/20p dual stake, and 90% for family and friends. When we had builders in recently, I must have accidentally knocked the switch down to 70%... don't know how that happened... heh.

Cheers :)

In Topic: MayGay 'Fruit'n'Nudge' Club Help...

05 March 2007 - 03:44 PM

I'm guessing it's something to do with the DIP switches?

There's 2x banks of 8 switches on the EPOCH board, but no indication of what is what.

I bet one of those is the option there... :) but WHICH ONE?? lol.

Please help me.


In Topic: MayGay 'Fruit'n'Nudge' Club Help...

25 February 2007 - 01:05 PM

Hello dear friends...

After a few home modifications to my machine, I'm now in need of a little more help with my machine.

How can I alter the CashPot / Reserve levels? I did a RAM reset, but they stop at £250... can't find a way to do it in Test Mode either.

Also, my power-supply buzzes. Vibration-wise, from the transformer. i've opened it and lagged it which has eased it slightly, but it's still noisy... as is the speaker. It buzzes "in time" with the flashing security light on the front, near the refil key.

A nice mod for me, was to replace the refil keyswitch with a 3way switch, as it's used in the home... refil, normal, demo - without opening up. :)

If anyone can help, would be well pleased. :)


In Topic: MayGay 'Fruit'n'Nudge' Club Help...

29 October 2006 - 12:33 AM

Just to say - it's funny what 'experience' can show, as opposed to "official" knowledge. As for entering test mode (taken from the machine's manual direct from Maygay):

Initiating Test Mode
To enter test mode the machine must be turned on and the service door open. If the test switch is pressed once, the machine will enter test mode.

Then it goes on about buttons LH1 LH2 LH3 and RH1 RH2 RH3 etc. To start with, I figured that RH1-4 were REEL HOLD buttons - but since I saw some LH buttons, I guess they're just counted from the left (or right) by X number - (LH1 being the leftmost button, RH1 being the rightmost button etc.)

Nowhere in the whole of the manual does it tell you what the red and green buttons are for, nor the green button down below. And there's no single mention of the button on the EPOCH board itself.

Thanks for all your help folks...

And er... "thanks" for all your "help" Maygay manual.


PS: Does anyone have an NV4 with serial loom going spare? ;)