Jpm Maximum overdrive impact tech
Can anyone help played machine last Sunday no probs
left machine on came back about an hour later machine dead as a dodo
Will not initialise a few random charecters on alpha numeric sometimes
Ist reel trys to move when powering up but status led on motherboard stays on constant not blinking as usual
all fuses on power supply seem good Leds lit
just will not boot ....... suspect impact board gone down
Anybody on here have any other things I could try or any ideas any
input would be greatly appretiated

Anyone help my machine has died
Started by ollyboy, Oct 03 2006 07:25 PM
2 replies to this topic
#1
Posted 03 October 2006 - 07:25 PM
#2
Posted 03 October 2006 - 08:40 PM
double check that the program card hasn't just come loose.
if it ok then its either the gamecard or the impact board but it sounds like the impact board.
baz
if it ok then its either the gamecard or the impact board but it sounds like the impact board.
baz
#3
Posted 03 October 2006 - 09:31 PM
Hi all
baz thanks for the reply
I've re seated both sound and gamecards in the board
and machine is still the same the only other thing that did happen
was that when I plugged it in it tripped out my breaker in my fuseboard
a couple of times will take out power supply and check voltages +5 +12 +24 etc tomorrow , also the leds on the reels are alight thats the only things that light up apart from status light on impact board and as i said a couple of random charecters on alpha/num display
.............still hoping .....will update asap
thanks too all who have read so far
baz thanks for the reply
I've re seated both sound and gamecards in the board
and machine is still the same the only other thing that did happen
was that when I plugged it in it tripped out my breaker in my fuseboard
a couple of times will take out power supply and check voltages +5 +12 +24 etc tomorrow , also the leds on the reels are alight thats the only things that light up apart from status light on impact board and as i said a couple of random charecters on alpha/num display
.............still hoping .....will update asap
thanks too all who have read so far
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users