Jump to content


Photo
- - - - -

nv4 note acceptor


  • Please log in to reply
6 replies to this topic

#1 pedro3178

pedro3178

    Junior Member

  • New Members
  • 61 posts

Posted 26 January 2010 - 01:47 PM

Hi guys!

I have a red gaming machine and it can take the nv4 note acceptor i just wanted to know if these things are easy to fit and if there is anything i should know first it has the mpu5 board fitted if that helps? :huh:

thanks!

#2 pricey2007

pricey2007

    Junior Member

  • New Members
  • 12 posts

Posted 19 April 2010 - 04:11 PM

just make sure you loom and right bracket to fit it, pretty stright forward.

#3 impact

impact

    Error 9.4

  • Regulars
  • 1280 posts

Posted 19 April 2010 - 06:20 PM

What red gamming you got a genesis or a horizon.If it`s a genesis a nv4 parallel or if you got a horizon nv4 set to cctalk/serial other then that easy as P.
.._-=It`s not a problem only a challenge =-_..

#4 youbrokeit

youbrokeit

    sdrawkcab tib elttil A

  • New Members
  • 60 posts

Posted 19 April 2010 - 08:38 PM

Aye, definitely has to be easy - even I managed to do it.

In fact, I even managed to reprogram my NV4 with the new note-faces, so it'd take the latest £20 notes.

A bit of fiddling, and you're sorted!

#5 DeJaVu

DeJaVu

    Junior Member

  • New Members
  • 11 posts

Posted 28 April 2010 - 03:41 PM

......... :goofy: Guess wont be a needed to Set - reset - BNV Key... :eek:
"Take-it-easy & Enjoy"
DeJaVu

#6 keranov85

keranov85

    Newbie

  • New Members
  • 7 posts

Posted 19 January 2013 - 12:35 PM

Hi I'have a problem , 
The NV4 note acceptor not taking any notes on Bell fruit machines (Cops and Robbers Gold and Platinum, and on Bullseye) 
I'have tried to set up the BNV code on test mode but it coming a funny error -  BNV Not Recognise, dos'n give me to change the BNV at all.
But if I put a note in the note acceptor during a test mode - works perfectly 
The hopper is full and the dip switch 8 is ON 
Any ideas?
Thank You!


#7 impact

impact

    Error 9.4

  • Regulars
  • 1280 posts

Posted 19 January 2013 - 03:55 PM

Your Nv4 need to be programmed as Nv4 CC/Talk. But an old machine like you should be using a NV4 parallel. Ok turn machine off connect Nv4 up boot machine up. Now if you can`t see a BNV key on your Nv4. Don`t try putting any key in. Reboot machine now check your float should see it has changed and at the booting up stage the nv4 should of tryred to start also.

 

How ever if it was a BNV key nv4 the key has been use and needs to be reset. (Only know how to reset these using a DA1 programmer)


.._-=It`s not a problem only a challenge =-_..




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users