Ace golden mile error code help please

[carol1869]

Hi ive had the machine for a while now and when u switch it on it goes through it sequence etc then comes up with error 4300 hope some one can help us thanks carol

[Bencrest]

AFAIK 43 00 is a button stuck alarm....make sure that they are all moving when the machine is off, give them a push and see if they come out again smoothy, e.t.c

BarcrestBenito

[carol1869]

hi well ive checked all the buttons along the front even removed them and check them with a multi meter and they all seem fine but its still comeing up with error 4300 thanks for any help

[DildoDez]

is 43 00 not a payout alarm? or is that the 41 xx series?

[Bencrest]

Hmmm...I'm using the IMPACT tech errors - not sure which tech the machine in question is though. A payout error would be 01-44 in the case of £1 [shown as '0144']....I think.

When you turn the machine on, does it make a crunching noise as well as the error messages? A machine will normally try to payout from the hopper before sending an alarm signal. Having said that, if the machine uses tubes, it could be that a tube is empty.

I'd recommend that you post over at www.fruitforums.com and www.mfme.co.uk as well as over here - simple reason being that not everyone over there posts over here, and the MFME site is where the people that code the JPeMulator stay.

Either way, I hope you get it sorted ASAP

BarcrestBenito

[edwardb]

Bloody hell....trawling the depths of my mind here.

I might be wrong but I think it is be a "100Hz loop sense failure" which is caused by a faulty power supply.

I used to own a Ghosttrapper machine which had this fault, and I ended up scrapping it because I couldnt get hold of another PSU. God knows where you'd look other than eastern European machine suppliers who bought loads of old Ace cabs years back and have probably made their own PSU. Sad to say but unless you're an expert on Ace machines you're probably screwed.

Sorry!

[Bencrest]

LOL

Just realised, from an emulated fruit machine, 4300 is the ON OFF alarm on IMPACT tech.

Turn the machine on, give the alarm about 10 seconds, and it should stop and let you play as usual.

Failing that, I haven't a clue.

BarcrestBenito